Parking Brake Lever Trim

Parking Brake Lever Trim

Special tools, testers and auxiliary items required

• Puller (T10055)

• Seal installer (T10136/1)

• Disassembly wedge (3409)

Removing






- Unclip the front trim from the parking brake lever - 1 - - arrow -.

- Set the parking brake.






- Pull the parking brake lever trim - 1 - on the parking brake lever up and over so that it is "inside-out" - 2 - and pull it over the handle.

- Carefully unclip the parking brake lever trim- 1 - on the handle - arrow - and pull it off.

- Position the puller (T10055) - 1 - on the handle - 2 -.






- Use the (T10055) to pull the handle - 2 - off of the parking brake lever - 3 -.

Installing

Install in reverse order of removal. Note the following:

Do not reuse the handle for the parking brake lever.

- Set the parking brake.

• Put the handle and the parking brake lever trim onto the parking brake lever.

• Pay attention to the direction of installation before installing the parking brake lever trim!

- Remove the handle - 2 - and adhesive strip - arrows - to prevent damage.






- Install the handle and the parking brake lever trim with the (T10136/1) - 1 -.

- Move the handle and the parking brake lever trim - 1 - carefully up the parking brake lever until dimension - a - is reached.






Dimension a = 10 mm ± 1 mm

- Remove the adhesive tape.

- Pull the parking brake lever trim - 1 - up and over the handle.






- Install the parking brake lever trim- 1 - in the groove - arrow A - on the handle.

- Install the parking brake lever trim - 1 - in the center console and clip it into the front - arrow B -.