Front Door Window, Door Window Adjusting Angle

Door Window Adjusting Angle






Install the door window - 5 - as shown, into the inner door seal - 8 - - arrows c -. The offset with respect to the side window is 1 mm.

- Remove the front door trim.

- Remove the cap for the front window regulator nut on the underside of the door.

- Remove the cap for the upper rear window regulator nut on the underside of the door.

- Loosen the front window regulator nut - 2 - and adjust the front window regulator - 1 - by sliding it - arrows a -.

- Loosen the window regulator nut - 3 - and adjust the rear window regulator - 1 - by turning the bolt - 4 -.

- Adjust the front and rear window regulator to the desired dimensions.

- Tighten the window regulator nuts - 2 - and - 3 - to the tightening specification: 8 Nm.

Guide the door window - 5 - in the center - arrows b - between the inner window shaft seal - 6 - and the outer window shaft seal - 7 -.