Rear Suspension, Multi-Link Rear Suspension

Left Rear Level Control System Sensor

Special tools, testers and auxiliary items required

• Torque Wrench 5-50 Nm (V.A.G 1331)

Removing

- Disconnect the harness connector - 1 -.






- Remove the bolts - 2 - from the lower transverse link.

- Remove the bolts - 3 - from the subframe.

- Remove Left Rear Level Control System Sensor (G76).

Installing

Install in reverse order of removal. Note the following:

The lever on the left rear level control system sensor must point toward the outside of the vehicle.

- Perform a basic setting on the headlamps after replacing them with the Vehicle Diagnostic Tester.

Tightening Specifications