Driver Front Airbag Crash Sensor G283, USA

Driver Front Airbag Crash Sensor G283, USA

• The driver front airbag crash sensor (G283) is located on the left side of the lock carrier on the front.

Removing

The general safety precautions for working on airbag, belt tensioner and battery cut-out units (pyrotechnic components) must be observed. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units General Safety Precautions.

- Disconnect the battery.

- Release the connector lock and disconnect the connector - 1 - from the driver front airbag crash sensor (G283) - 3 -.






- Remove the bolt - 2 - (4.5 Nm) and the driver front airbag crash sensor (G283) - 3 -.

Installation

- Install the driver front airbag crash sensor (G283) - 3 -. The tab - arrow A - must fit into the hole - arrow B -.






• This assures the driver front airbag crash sensor (G283) will be installed correctly.

- Install the bolt - 2 - and tighten it to 4.5 Nm.

- Connect the connector - 1 - and lock it.

- Turn on the ignition.

Make sure no one is in the vehicle.

- Connect the battery.