Headlamp Switch: Service and Repair

Headlamp Switch (E1)

The headlamp switch (E1) consists of:

• Fog Lamp Switch (E7)

• Rear Fog Lamp Switch (E18)

• Headlamp Switch Light (L9)

• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( trim removal wedge (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

Removing

- Turn the headlamp switch to "0".

- Push the headlamp switch handle in - arrow 1 - and turn it a little to the right - arrow 2 -.

- Hold the rotary handle in this position and remove the headlamp switch from the instrument panel by the handle - arrow 3 -.






- Disconnect the connector.

Installing

Install in reverse order of removal. Note the following:

- Connect electrical connector.

- Hold headlamp switch firmly and press in rotary handle of headlamp switch - arrow 1 - and turn slightly toward right - arrow 2 -.






- Hold the rotary handle in this position and insert the headlamp switch into the instrument panel - arrow 3 -.

- Turn the rotary switch to the "0" position, release it and engage the headlamp switch.