Rear Lid Side Adjusting Buffer, Adjusting

Rear Lid Side Adjusting Buffer, Adjusting

• The following describes adjusting the left side adjusting buffer. Adjusting the right side adjusting buffer is identical.

• Stop on side panel is installed, refer to => [ Side Adjusting Buffer and Stop ] Side Adjusting Buffer and Stop

- Unclip the cap - 1 - from the adjusting buffer - 3 -.






- Slightly loosen the bolt - 2 - on the adjusting buffer - 3 - until the adjusting buffer moves easily.

- Slide the adjusting buffer - 3 - in the direction of the - arrow - until it stops.

- Close the rear lid above the center to initial locking position.

- Open the rear lid again and tighten the bolt - 2 -.

Tightening specification - 2 -: 8 Nm

- Unclip the cap - 1 - from the adjusting buffer - 3 -.

- Check the adjustment and repeat if necessary.