After-Run Coolant Pump (V51)

After-Run Coolant Pump (V51)

Special tools, testers and auxiliary items required

• Hose Clamps up to 25 mm Dia. (3094)

• Hose Clip Pliers (VAS 6362)

Removing

Risk of scalding due to hot steam and hot coolant:

• The coolant system is under pressure when the engine is warm.

• Wear protective goggles and protective clothing to prevent damage to eyes and scalding.

• Reduce pressure by covering the coolant expansion tank cap with a cloth and carefully opening.

- Open the coolant expansion tank cap.

- Remove the noise insulation..

- Disconnect the after-run coolant pump connector - 1 -.






- Place the drip tray for VAS 6100 (VAS 6208) under the engine.

- Clamp off the coolant hoses to the after-run coolant pump using the hose clamps up to 25 mm dia. (3094)

- Reposition the hose clamps - arrows - and disconnect the coolant hoses.

- Remove the after-run coolant pump bracket bolt - 2 -.

Installing

• Tightening specifications, refer to => [ After-Run Coolant Pump (V51) Overview ] After-Run Coolant Pump (V51) Overview.

Install in reverse order of removal. Note the following:

- Check the coolant level. Refer to => [ Coolant, Draining and Filling ] Service and Repair.