Rear ABS Wheel Speed Sensor, Torsion Beam Suspension with Drum Brakes

Rear ABS Wheel Speed Sensor, Torsion Beam Suspension with Drum Brakes

Removing

- Raise the vehicle.

- Release and remove the connector - 1 -.






- Remove bolt - arrow -.






- Remove the rear speed sensor - 1 - from the rear axle.

Installing

Install in reverse order of removal. Note the following:

- Clean the inside of the hole and coat it with hot bolt paste G 052 112 A3 before installing the rear speed sensor.

- Install the rear speed sensor into the hole in the rear axle and tighten it.

Tightening Specification