Wiper Frame with Linkage and Windshield Wiper Motor (V), Installation

Wiper Frame with Linkage and Windshield Wiper Motor (V), Installation

• When connecting battery, always perform work procedure as described in repair information. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair. Not adhering to sequence will result in the deactivation of Main Battery Switch -E74- and subsequent damage to electrical system components.

• Observe notes for threaded connections of battery terminals. Refer to => [ Battery Post/Terminal ] Battery Post/Terminal.

- Connect battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Let windshield wiper motor run to rest position. Connect the connector to the windshield wiper motor, turn on the ignition and briefly operate the windshield wiper switch (one-touch wiping).

• The hood ( Front hood switch (F266) ) must be closed in order to use the windshield wipers.

- Turn off the ignition and disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Install the wiper frame with the linkage and windshield wiper motor in reverse sequence.

- Tighten the bolts for the wiper frame to the tightening specification given in the overview. Refer to => [ Windshield Wiper System Overview ] Windshield Wiper System Overview.

• If Wiper motor control module (J400) or windshield wiper motor is replaced, Wiper motor control module must be coded. Refer to => [ Wiper Motor Control Module (J400), Coding ] Testing and Inspection.

- Connect battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.