Door Window

Door Window

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Torque Wrench (V.A.G 1783)

• Roller (T 10314)

• Release tool (T 10236)

• Trim removal wedge (3409)

Removing

• The bolt - 3 - can have a left or right thread, depending on its installed position.

• The bolts has a right thread if the bolt head has an inner TORX.

• The bolts has a left thread if the bolt head has an outer TORX.






Perform the following:

- Remove the rear door trim.

- Pry out the cap.

- Lower the door window - 1 - until the bolts - 3 - in the window regulator opening are accessible.

• The bolts has a right thread if the bolt head has an inner TORX.

• The bolts has a left thread if the bolt head has an outer TORX.

- Loosen the bolt - 3 - but do not remove it.

- Separate the clamping bracket - 2 - slightly.

• If the step is not possible due to a malfunction in the window regulator, the motor is removed. Then the window can be moved to the necessary position.






- Remove the rear trim - 2 -. Refer to => [ Rear Door Trims ] Rear Door Trims.

- Pull the back part of the window guide out of the mount.

- Remove the door window - 1 - upward at an angle - arrows b - with respect to the outside of the vehicle from the window shaft.

Installing

• The spreader plug and spreader pin must be replaced when performing assembly work on the door window.

• Check the door window - 1 - for damage before installing the spreader plug - 3 - and the expanding pin - 4 -.






Perform the following:

- Insert the door window - 1 - in the window guides in the - direction of arrow a -.

• Make sure the door window is inserted correctly in the window guide.

- Without using any pressure, guide the door window - arrow c - into the clamping brackets - 3 -.

- Align the door window inside the window frame - arrow b -.






- Tighten the clamping screws - 3 - (quantity: 2). Tightening specification: 8 Nm.

• The bolts has a right thread if the bolt head has an inner TORX.

• The bolts has a left thread if the bolt head has an outer TORX.

- Continue by performing the steps used in removal in reverse order.

• A function test must be performed before the door trim is installed.