Cornering Lamp Bulb

Cornering Lamp Bulb

• The following illustrations show the procedure for replacing the right cornering lamp bulb (L149) in the right headlamp. The procedure for replacing the left cornering lamp bulb (L148) in the left headlamp is similar, except the air filter housing must also be removed.

Removing

- Pull off cover cap - 1 -.






For the left side only

- Remove the air filter housing.

Continuation for both sides

• In order to be able to remove and install the cornering lamp bulb, the reflector support must be disengaged from the ball head of the adjuster.

- To disengage the reflector support, press it - 1 - in the area of the upper mounting screw in the - direction of arrow -.






- Turn the cornering lamp socket - 1 - counterclockwise in - direction of arrow - to disengage it.






- Carefully remove the cornering lamp bulb out of the headlamp, while being careful of connected wires.

- Remove the cornering lamp bulb - 1 - in - direction of arrow - out of the socket - 2 -.






Cornering lamp bulb : H7 12V, 55W

Installing

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

Install in reverse order of removal. Note the following:

• Due to lack of space, the cornering lamp bulb must be replaced in the following sequence.

- Make sure the reflector support is the disengaged position.

- Insert the socket and the cornering lamp bulb into the reflector support.

• For reasons of clarity, locking the cornering lamp bulb in the reflector support is illustrated as a cutout view.

- Position the metal tab - 2 - on the socket in the recess in the reflector support - 3 -, as shown in the illustration.






- Turn the bulb socket - 1 - forward with light pressure in the - direction of the arrow - to lock the socket inside the reflector support.

- Engage the reflector support once again; when doing this, it should audibly engage.


When installing the cover cap, make sure the cap is properly seated. It is destroyed by entry of water into headlamp.

- Seal the headlamp with the cap.

- Check headlamp for function.