Compass: Service and Repair

Compass Magnetic Field Sensor (G197)

The compass magnetic field sensor is attached to the rear of the roof near the roof end strip.

Removing

- Turn off the ignition and all electric consumers and remove the key.

- Lower the rear headliner..

- Remove the compass magnetic field sensor - 1 - from the roof with a small screwdriver.






- Disconnect the connector - 2 - and remove the compass magnetic field sensor - 1 -.

Installing

The compass magnetic field sensor includes adhesive tape.

- Clean the adhesive surface on the roof.

- Connect the connector - 2 - to the compass magnetic field sensor - 1 -.






- Peel off the protective film on the compass magnetic field sensor.

Align the compass magnetic field sensor with the edge of the roof end - 4 - and the mark - 3 -.






- Firmly press the compass magnetic field sensor - 1 - onto the adhesive surface.

Install in reverse order of removal.

- Calibrate the compass.