Rear Bumper License Plate Holder

Rear Bumper License Plate Holder

• The license plate holder is not installed on all models for all markets.

• The license plate holder can have different sizes depending on the market.

• The contour of the bumper cover determines the height of the license plate holder.

• Drill 12 mm holes.






With Holes

- Position the license plate holder - 5 - on the rear bumper cover and press the clips - 4 - in.

- Tighten the pop rivet nuts - 3 -.

Without Holes

- Align the license plate holder - 5 - on the rear bumper cover - 1 - with the rear lid striker pin - 2 -.

- Set the drill stop depth to 12 mm and drill the holes.

- Position the license plate holder - 2 - on the rear bumper cover and press the clips - 4 - in.

- Tighten the pop rivet nuts - 3 -.