Wiper Motor From Wiper Frame

Wiper Motor From Wiper Frame

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Pry Lever (80-200)

• In order to be able to remove the wiper frames with linkages and wiper motor, the wiper arms, plenum chamber cover and plenum chamber bulkhead must be removed.

Requirement

• Wiper frame with linkage and wiper motor removed

Removal

- Pry off ball head - arrow - of linkage - 1 - from motor crank using (80-200).






- Remove the nut - 1 -.






- Remove motor crank - 2 - from wiper motor shaft.

- Remove mounting bolts - arrows - and remove wiper motor with control module out of wiper frame.






Installation

- Insert wiper motor with control module into wiper frame and secure it with mounting bolts - arrows -.

- Tighten threaded connections to 8 Nm.

Tightening specifications overview, refer to => [ Windshield Wiper and Washer System, Tightening Specifications ] [1][2]Specifications.

- Place motor crank - 1 - onto wiper motor shaft.






Distance - a - to stop - 2 - must be 3 +/- 1 mm.

- Screw motor crank to wiper motor shaft with nut - 3 - and tighten it to 18 Nm.

Tightening specifications overview, refer to => [ Windshield Wiper and Washer System, Tightening Specifications ] [1][2]Specifications

- Push ball head - arrow - of linkage - 1 - onto motor crank.