High Pressure Sensor / Switch: Service and Repair

High Pressure Sensor (G65)

• The high pressure sensor - 1 - may also be installed on a different side in the vicinity of the condenser, depending on the engine version.

• To loosen, counter-hold the side of the refrigerant line with a suitable tool.

Removal






- Remove the front noise insulation.

- Disconnect the connector from the high pressure sensor (G65) - 1 -.

- Remove the high pressure sensor - 1 - from the refrigerant line connection.

Installation

Install in reverse order of removal.

- Replace the O-ring.

To tighten, counter-hold the side of the refrigerant line with a suitable tool.

Tightening specification 8 ± 1 Nm