Hydraulic Fluid Filter - ASMT: Service and Repair

Oil Filter

• The transmission oil filter usually does not need to be replaced.

• Changing the transmission fluid filter "yes or no". Refer to => [ When To Change the Oil Filter ] General Repair Information.

Removing

- Move the selector lever into the "P" position.

- Remove the air filter housing. Refer to one of the following:

Gas engines

- Remove the battery and battery tray.

• A little bit of oil remains inside the filter housing. This will drain out once the filter housing is removed.

• Lay some cloths down near the filter before removing it.

- Loosen the filter housing - arrow - approximately 7 turns.






- Wait 10 seconds.

This way the oil can drain from the filter housing back into the transmission.

- Remove the filter housing and filter.

Installing

Install in the reverse order of removal. Pay attention to the following:

- Clean thoroughly any areas on the transmission that get wet with oil.

- Install the oil filter with the collar - arrow - on the bottom.






- Install the oil filter housing and tighten it to 20 Nm.

Further installation is performed in the reverse sequence.

- Check the oil level and fill as necessary. Refer to => [ Transmission Oil Level, Checking and Filling ] Transmission Oil Level, Checking and Filling.