Steering Gear: Description and Operation

Power Steering Gear Assembly Overview






1 Right Tie Rod End

• marked with "R"

• Check dust caps for damage and correct seating

• Conical pin must be free of grease and oil

• If necessary, clean using dry rag, do not use cleaning agents

2 Nut

• 70 Nm

3 Right Tie Rod

• 100 Nm

• Removing and installing, refer to => [ Tie Rod ] Removal and Replacement.

4 Spring Clamp

5 Boot

• Check for damage.

• Must not be twisted when toe is being adjusted.

6 Clamp

• Replace

7 Seal

• Replace

8 Control Line

• 7 Nm

• When installing, make sure that the O-ring is not damaged.

• Make sure not under tension when installing.

• Do not damage surface, repair paint damage as necessary.

9 Control Line

• 7 Nm

• When installing, make sure that the O-ring is not damaged.

• Make sure not under tension when installing.

• Do not damage surface, repair paint damage as necessary.

10 Bolt

• 12 Nm

11 Backing Plate

12 Power Steering Gear

• Removing and installing, refer to => [ Power Steering Gear ] Power Steering Gear.

13 Left Tie Rod End

• Marked with "L".

• Check dust caps for damage and correct seating.

• Conical pin must be free of grease and oil.

• If necessary, clean using dry rag, do not use cleaning agents.

14 Left Tie Rod

• Removing and installing, refer to => [ Tie Rod ] Removal and Replacement.

• 100 Nm