Mechanical Belt Height Adjuster

Mechanical Belt Height Adjuster

• Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the same manner.

Removing

- Remove B-pillar trim. Refer to => [ B-Pillar Trim ] B-Pillar Trim.

- Remove bolt - 1 - (50 Nm) and remove belt relay - 2 - from belt height adjuster.

- Remove bolt - 3 - (4.5 Nm) and separate belt height adjuster - 4 - from mounting in carrier plate.





Installation

- To install, perform the steps used for removal in reverse order.