Rear Door Window Motor: Service and Repair

Window Regulator Motor

• Removing and installing is described only for the right window regulator motor. Removing and installing the left window regulator motor is derived accordingly from this.

Removing

- Remove door trim.





- Fix window using adhesive tape so that it does not slip down.

- Remove the three bolts - 2 -.

- Disconnect the connector - 3 -.

- Remove window regulator motor with control module - 1 - from subframe.

Installation

- Place window regulator motor on and pull door window lightly up and down so that splines are located better between motor and cable drum.

Tightening specification for window regulator motor screws: 3.5 Nm

- Drive window regulator twice upward and downward to stop. By doing this, window regulator motor is normed and ready for operation and activates pinch protection.

- Continue by performing the steps used in removal in reverse order.