Driver Side Rear Side Airbag Crash Sensor G256

Driver Side Rear Side Airbag Crash Sensor G256

• The driver side rear side airbag crash sensor (G256) is installed on the driver side in front of the rear wheel housing.

Removing


Follow all Safety Precautions when working on an airbag. Refer to => [ Airbags Safety Precautions ] Airbags Safety Precautions.

- Disconnect the battery.

- Move the left rear bench seat as far forward as possible.

- Remove the rear wheel housing trim:

• without rear side airbags: => [ Rear Wheel Housing Trim without Rear Side Airbag ] Rear Wheel Housing Trim without Rear Side Airbag

• With rear side airbag: => [ Rear Wheel Housing Trim with Rear Side Airbag ] Rear Wheel Housing Trim with Rear Side Airbag

- Press the connector lock and remove the connector - 1 - from the crash sensor - 3 -.






- Remove bolt - 2 - (6 Nm).

Installation

- Install in reverse order of removal.

- Turn on the ignition.


Make sure that no persons are in the vehicle.

- Connect the battery.