Line and Breather for Clutch Slave Cylinder

Line and Breather for Clutch Slave Cylinder

Line - 4 - to Breather Assembly - 1 -, Removing and Installing





- Open the clip - 2 - with a screwdriver or a pointed tool and remove the line - 4 - from the breather assembly- 1 -.

- Push the line - 4 - and O-ring - 3 - into the breather valve - 1 - until the clip - 2 - audibly locks.

- Pull on the line to make sure it is tight.

Clutch Slave Cylinder Breather Assembly - 4 -, Removing and Installing





- Open the clip - 2 - with a screwdriver and remove the breather assembly - 4 - from the clutch slave cylinder - 1 -.

- Check the O-ring - 3 - on the clutch slave cylinder. Press in the breather at slave cylinder connector until the clip engages audibly.

- To check, pull on the breather assembly.

- Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] Clutch System, Bleeding.