Installing

Installing

Install in reverse order of removal. Note the following:

- Make sure the centering sleeves are pressed into the engine flange. Refer to => [ Tightening Specifications ] Tightening Specifications.

Make sure the torque converter is installed correctly. It must be easy turn easily by hand and the entire circumference must be equally deep inside the transmission.

• Carefully rotate the engine further!

• Be careful of the engine when guiding the transmission onto the engine. Hold the starter ring gear steady from the outside with a screwdriver. When installing, studs are located in the bores of the rive plate.

The engine and the transmission must be secured to the mounts free of tension.

- Make sure the bolts are in their old position when tightening the transmission mount/bracket bolts. Tightening specification, refer to => [ Tightening Specifications ] Tightening Specifications.

- Adjust the selector lever cable. Refer to => [ Selector Lever Cable, Adjusting ] Adjustments.

- Check the transmission fluid level. Refer to => [ Transmission Fluid Level, Checking and Filling ] Transmission Fluid Level, Checking and Filling.

- Perform a basic setting. Connect the vehicle diagnosis, testing and information system (VAS 5051) and then select "perform basic setting" in Guided Functions.