Steering Column Combination Switch (E595), Valeo

Steering Column Combination Switch (E595), Valeo


Follow the specified sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

Depending on equipment, the Steering Column Combination Switch consists of the following components and cannot be disassembled:

• Turn Signal Switch (E2)

• Windshield Wiper Switch (E)

• Cruise Control Switch (E45)

Removing

- Remove the steering wheel.

- Remove steering column trim.

- Remove Steering Column Electronics Control Module (J527). Refer to => [ Steering Column Electronics Control Module (J527), Valeo ] Steering Column Electronics Control Module (J527), Valeo.






- Unlock both releases - arrows - and remove the entire steering column combination switch from the steering column switch base carrier.

Installing

- Push the steering column combination switch onto the guide on the steering column switch base carrier until it latches.

- Install all components in reverse order of removal.