Ribbed Belt Pulley, Denso A/C Compressor Overview

Ribbed Belt Pulley, Denso A/C Compressor Overview

• This type of ribbed belt pulley is installed on "7SEU17C" A/C compressor.

• Different versions of the ribbed belt pulley may be installed, depending on A/C compressor construction type and engine version.

• Ribbed belt pulley, removing and installing, refer to => [ Ribbed Belt Pulley, Denso A/C Compressor ] Ribbed Belt Pulley, Denso A/C Compressor.






1 Cap With Locking Ring

• Remove carefully using a small screwdriver or needle-nose pliers (pay special attention to ribbed belt pulley when doing this).

2 Drive Plate

3 Circlip

• Always replace

• Install on correct side (flat side toward A/C compressor).

4 Spacer

5 Ribbed Belt Pulley

• The ribbed belt pulley is made of plastics and is sensitive to impact, be especially careful when handling it.

• Different versions.

6 A/C Compressor

• Depending on engine and market version, different versions can be installed.

• Clean A/C compressor flange before sliding on ribbed belt pulley.

7 Rubber Element

• Quantity: 6

• Decouples the ribbed belt pulley from the A/C compressor input shaft and dampens vibration and noise.

• For installation, lightly coat rubber elements, for example, with tire mounting paste or a soap solution (as a lubricant).