Leak Detection Pump: Service and Repair

EVAP Canister and Leak Detection Pump

Removing

- Remove the rear right wheel housing liner.

- Disconnect the vent lines - 1 and 2 -.





Press in the securing ring - A - to disengage the lines.

- Disconnect the connector - 3 -.

• Illustration shows a metal fuel tank. Steps for the plastic fuel tank are similar.

- Disconnect the vacuum line - 3 -.





- Remove the right rear side turn signals.

- Remove the bolt - 3 -.





- Remove the bolts - 1 and 2 -.

- Remove the Evaporative Emission (EVAP) canister with the Leak Detection Pump (LDP) (V144).

Removing the LDP

- Disconnect the connecting hose from the LDP.

- Remove the three bolts.

- Remove the LDP from the EVAP canister

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

• Connect ventilation lines until they engage audibly.

• Make sure lines and EVAP canister are locked securely.

Tightening Specifications