Instrument Cluster, From 06.99

Function 02 - Checking DTC Memory

• DTCs stored in memory along with corresponding malfunction descriptions can only be displayed by initiating the on board diagnostic program and checking DTC memory (function 02).

- Connect scan tool (VAG 1551) , input address word 17, "Instrument cluster", and press -> button until "Select function XX" appears in display => [ VAG 1551, Connecting and Selecting Functions ] VAG 1551, Connecting and Selecting Functions.

- Switch on printer with the Print button (indicator lamp in key lights up).

Indicated on display (select function):

Rapid data transfer HELP
Select function XX

- Press buttons 0 and 2 to select function 02, check Diagnostic Trouble Code (DTC) memory.

Indicated on display:

Rapid data transfer Q
02 - Interrogate fault memory

- Press Q button to confirm input.

The number of stored malfunctions appears in the display.

X faults recognized!


The number of stored DTCs or "No DTC s recognized" appears in the display and are printed out one after another.

- When the last DTC has been displayed and printed out, rectify malfunctions as described in DTC table => [ DTC Table ].

If "No DTC recognized" is displayed the program will return to the initial point after pressing -> button.

No fault recognized! ->


Indicated on display (select function):

Rapid data transfer HELP
Select function XX

If display not indicated as shown => Scan tool operating instructions

- End output (function 06) => [ Function 06 - End Output ] Function 06 - End Output.

- Switch off ignition and disconnect Data Link Connector (DLC).