Front Axle

ABS Wheel Speed Sensor

Removing

- Raise vehicle.

- Disconnect harness connector - 1 - from wheel speed sensor wire and wheel speed sensor.





- Remove bolt - 2 - from wheel bearing housing.

- Disconnect ABS wheel speed sensor from wheel bearing housing.

Installing

- Before inserting wheel speed sensor, clean inner surface of hole and coat sensor completely with securing grease (G 000 650 ).

- Insert wheel speed sensor in hole of wheel bearing housing and tighten bolt to 8 Nm.

- Connect wheel speed sensor and sensor wire.

- Turn wheels completely to left and right stop positions and check clearance to ABS wheel speed sensor wiring.