Steering Column Switch, through 05.10

Airbag Spiral Spring/Return Spring with Slip Ring (F138)


When removing, the Airbag Spiral Spring/Return Spring With Slip Ring must not be twisted out of the center position and the wheels must be "straight ahead".

Removing

- Lift the retaining strap - arrows - on the airbag spiral spring/return spring with slip ring - 1 - slightly and remove the airbag spiral spring/return spring with slip ring toward the rear and from the steering column.






Installing

Install in reverse order of removal. Note the following:

The airbag spiral spring/return spring with slip ring must be in the center position and the wheels must be turned to the "straight-ahead position" when installing the airbag spiral spring/return spring with slip ring.

The airbag spiral spring/return spring with slip ring center position, which depends on the manufacturer, is depicted as follows:

• The color marked (black square) band - arrow - must be located in viewing window - 1 -.






• The color marked (yellow) band - arrow - must be located in viewing window - 1 -.






If a new Steering Angle Sensor (G85) is installed, then the work procedure "Basic Setting" must be performed. Refer to => [ Steering Angle Sensor (G85) Basic Setting ] Steering Angle Sensor (G85) Basic Setting.