Towing Module: Service and Repair

Towing Recognition Control Module (J345), from MY 10


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the left luggage compartment side trim panel.

- Remove the screws - 1 - and - 2 - and then remove the towing recognition control module - 4 - from the plate.






- Disconnect the connectors - 3 -.

Installation

Installation is performed in the reverse order of removal. Note the following:

After installing a new towing recognition control module, it must be coded. Refer to=> [ From MY 10, Coding ] From MY 10, Coding.