Wheel Bearing Assembly Overview

Wheel Bearing Assembly Overview






1 Suspension Strut

2 Tie Rod End

3 Socket Head Bolt

• Bolt point must face in direction of travel.

4 Bolt, 8 Nm

5 Left Front ABS Wheel Speed Sensor (G47)/Right Front ABS Wheel Speed Sensor (G45)

• Before inserting wheel speed sensor, clean inner surface of bore hole and coat with securing grease (G 000 650).

6 Cover Plate

7 Nut, 20 Nm + 90°

• M12 x 1.5

• Self-locking

• Always replace after removal.

8 Bolt, 10 Nm

9 Internally Vented Brake Disc

10 Bolt

• M16 x 1.5 x 80

• Hex head bolt = 200 Nm + 180° turn.

• 12-point bolt = 70 mm + 90° turn.

• Always replace after removal.

Vehicle must not be standing on its wheels when loosening or tightening

11 Bolt

12 Wheel Hub with Wheel Bearing

• Sensor ring for ABS is installed in wheel hub.

• Various versions

13 Wheel Bearing Housing

• Removal and installation, refer to => [ Wheel Bearing Housing ] Wheel Bearing Housing.

• With bolted brake carrier.

• If a wheel bearing housing is replaced, vehicle must then be aligned. Refer to => [ Wheel Alignment ] Wheel Alignment.

14 Wheel Bearing Housing

• Removal and installation, refer to => [ Wheel Bearing Housing ] Wheel Bearing Housing.

• With bolted brake carrier.

• If a wheel bearing housing is replaced, vehicle must then be aligned. Refer to => [ Wheel Alignment ] Wheel Alignment.

15 Bolt, 70 Nm + 90°

• M12 x 1.5 x 45

• Always replace after removal.

16 Drive Axle

• Removal and installation, refer to => [ Drive Axle, with CV Joints VL90, VL100 and VL107 ] Drive Axle, with CV Joints VL90, VL100 and VL107.

17 Nut, 70 Nm + 90°

• M12 x 1.5

• Self-locking

• Always replace after removal.