Compass, Calibrating

Compass, Calibrating

1. Bring up the main menu

- Switch the ignition on.

A vehicle pictogram will appear.






- Press the button - 1 - in the windshield wiper lever one time.

- To move back out of another menu into the main menu, hold the rocker switch - 2 - depressed for two seconds.

This procedure might have to be repeated until the main menu appears.

2. Bring up the menu "Settings"

- Press the top or the bottom of the rocker switch to highlight a point on the menu.

The marked menu item will be between the two horizontal lines. There is also a small triangle on the right side.






- Highlight "Settings".

- Press the button - 1 - in the windshield wiper lever.

The menu "Settings" is brought up.

3. Bring up the menu "Comfort"

- Highlight "Comfort" with the rocker switch - 2 -.

The menu "Comfort" is brought up.






4. Bring up the menu "Compass"

- Highlight "Compass" with the rocker switch - 2 -.

The menu "Compass" is brought up.

The following will appear in "compass":

1 - Direction

2 - Zone

3 - Calibration

4 - Back

5. Bring up the menu "Calibration"






Select Calibration and press the button - 1 - to confirm.

The following will appear in "Calibration":

1 - To calibrate, a full circle must be driven

2 - Calibrating

3 - Back

6. Bring up the menu "Calibrating"

Select Calibrate and press the button - 1 - to confirm.

The following will appear in "Calibrate":

1 - Driving in a full circle






- Press the button - 1 -.

- Drive in a full circle at a speed of less than 10 mph (20 Km/h).

"CAL" is indicated at the top in the display, next to the arrow for direction.

After completing the calibration, the indication "CAL" is replaced by the actual direction (e.g. "N" for North).