Lower Engine Compartment Cover, Version 2, Small Noise Insulation, Removing and Installing

Lower Engine Compartment Cover, Version 2, Small Noise Insulation, Removing and Installing

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)






• Cordless drill 12V/2.0 Ah (VAS 5826)

Removing






1. Sheet metal screws, tightening specification: 2 Nm


- Remove the screws - arrows - with a 12V/2.0 Ah cordless drill (VAS 5826).

- Remove noise insulation.

Installing






- Slide the noise insulation - 3 - into the bottom of the lock carrier - 2 - as illustrated.

- The narrow latches - arrow a - must be slid below or wide latches - arrow b - slid above the lock carrier edge - 2 -.

- Retaining tabs must engage over wide tabs in lock carrier holes when doing so.

- Tighten the bolts - arrows - to the tightening specification.