Lumbar Support Frame, Manual, Jetta from MY 2010 and Golf Wagon from MY 2010

Lumbar Support Frame, Manual, Jetta from MY 2010 and Golf Wagon from MY 2010

• The following describes removing and installing on the left side of the vehicle. Removing and installing on the right side is identical.

Removing

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove the front seat. Refer to => [ Front Seat ] Front Seat

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove front right seat trim. Refer to => [ Right Seat Trim ] Right Seat Trim

- Remove front left seat trim. Refer to => [ Left Seat Trim ] Left Seat Trim

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Left Front Seat Backrest

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove the lumbar support lever. Refer to => [ Lumbar Adjustment Lever, Jetta from MY 2010 and Golf Wagon from MY 2010 ] Lumbar Adjustment Lever, Jetta from MY 2010 and Golf Wagon from MY 2010

- Remove cover and upholstery from front seat backrest. Refer to => [ Front Seat Backrest Cover and Upholstery ] Front Seat Backrest Cover and Upholstery

- Remove the two bolts - 1 - from the actuator (1.5 +/- 1 Nm).

- Remove the side retainers - 2 - and - 3 - from the backrest frame.

- Remove the side springs.

- Remove the lumbar support - 4 - from the upper mounts - arrows - in the backrest frame.






Installing

- Install in reverse order of removal.