Rear Wheel Housing Crash Sensors, 2-Door, Golf 2004

Rear Wheel Housing Crash Sensors, 2-door, Golf 2004

• Removal and installation is described for the right side of the vehicle. Removing and installing on the left side is identical.

Removing


Always read the General Safety Precautions before working on airbags, belt tensioners and battery cut-out units (pyrotechnical components). Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions.

- Disconnect the battery.

- Remove the seat bench. Refer to => [ Bench Seat ] Bench Seat

- Remove the backrest. Refer to => [ Backrest ] Backrest

- Remove the B-pillar upper trim. Refer to => [ Upper B-Pillar Trim ] Upper B-Pillar Trim

- Remove side trim => [ Side Trim, 2-door ] Side Trim, 2-door

- Press connector lock - 1 - toward rear - arrow - and disconnect connector - 2 - from crash sensor - 4 -.

- Remove the two bolts - 3 - (9 Nm).






Installation

- Install in reverse order of removal.

- Switch on ignition.


Make sure no one is in the vehicle.

- Connect the battery.