Keyless Start Control Module: Service and Repair

Access/Start Authorization Control Module (J518)

Code the "access/start authorization" system after replacing the access/start authorization control module. Refer to=> [ Access/Start Authorization Control Module (J518), Coding ] Access/Start Authorization Control Module (J518), Coding.

Removing

- Remove the footwell vent on the driver side.






- Open the retainers - arrow - and remove the access/start authorization control module - 2 - together with the mount - 3 - from the brake pedal bracket. Pay attention to the wires still connected.

- Disconnect the connector - 1 - and remove the access/start authorization control module - 2 - from its mount - 3 -.

Installation

Install in reverse order of removal, noting the following:






- Install the access/start authorization control module - 2 - in its mount - 3 -.

- Slide the bracket and control module onto the guide on the brake pedal bracket until it latches.

- Connect the connector - 1 -.

Code the "access/start authorization" system after replacing the access/start authorization control module. Refer to => [ Access/Start Authorization Control Module (J518), Coding ] Access/Start Authorization Control Module (J518), Coding.