Window Regulator Motor

Window Regulator Motor

Removing

- Remove front door trim.





- Secure the door window with adhesive tape to prevent it from falling down.

- Separate connectors - 2 - from window regulator motor with control module - 1 -.

- Remove bolts - 3 - and remove the window regulator motor with control module - 1 - from assembly carrier.

Installation

- Install the window regulator motor with control module - 1 - and connect the connector - 2 -.





- Tighten bolts - 3 - for window regulator motor to tightening specification 3.5 Nm.

- Drive the window regulator up and down to the limit stops, twice. By doing this, window regulator motor is normed and ready for operation and activates pinch protection.

Then, continue in reverse order of removal.

• Before installing door trim, check function of door window.