Rear Suspension

Rear Vehicle Level Sensor

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1331)

• Vehicle diagnostic, test and information system (VAS 5051)

Assembly Overview





1. Subframe

2. Hex socket head bolt, 5 Nm

3. Transverse link, upper front

4. Self-locking nut, 8 Nm

5. Rear Level Control System Sensors (G76/G77)

Removing


Before starting work, stabilizer bars must be coupled in vehicles with decouplable stabilizer bars. Otherwise, there is the danger of injury caused by unintentional coupling.

- Raise vehicle.

- Pinch off electrical connection on rear level control system sensor.

- Remove bolts - 2 - and nut - 4 - and remove rear level control system sensor.

Installing

- Attach rear level control system sensor to subframe using bolts - 2 -.

- Install ball joint pin to top front transverse control arm using new nut - 4 -.

• Joint between lever of rear level control system sensor and coupling rod must point downward while doing so.

- Tighten all bolts to tightening specification.

- Lower vehicle on wheels.

- Perform basic setting for rear level control system sensor using (VAS 5051).