Differential Lock Motor

Differential Lock Motor

Special tools, testers and auxiliary items required

• Torque wrench (VAG 1331)

Removing

- Separate the two connectors at differential lock motor.

- Remove the differential lock motor - A - with holder for connector - B -, thereby removing the four bolts.





Installing

- Replace O-ring - arrow - on differential lock motor





• Differential lock motor is delivered as a replacement part with O-ring installed.

• O-ring is secured with a protective sleeve.

• You must remove protective sleeve before installing differential lock motor.

- Set the differential lock motor - A - with holder for connector - B - into the rear final drive, and install the four bolts.





- Connect the two connectors at differential lock motor.

- Checking gear oil in rear final drive. Refer to => [ Gear Oil, Checking ] Gear Oil, Checking.