3.2L, 3.6L

Generator, Coolant Cooled Overview






1 - Tension Roller

2 - Hex Socket Head Bolts

• 20 Nm

• M8 x 30 mm

3 - Fitting Bolts

• M8 x 28 mm

• 20 Nm

4 - Bracket

5 - Coolant Hose

• Connection diagram for coolant hoses, refer to => Engine Mechanical, Fuel Injection and Ignition 19 Description and Operation.

6 - Clamp

7 - Torx(R) Flat Head Bolt

• 9 Nm

• M6 x 16 mm

8 - Connecting Piece

9 - O-ring

• Always replace

10 - Generator

• B+ wire fastener to generator, 15 Nm, refer to => [ B+ Cable Mount on Generator ] Procedures.

• Neither the voltage regulator nor the carbon brushes can be replaced individually; if a repair is required, the entire generator must be replaced.

• Generator, removing and installing, refer to => [ Generator, Coolant Cooled ] Generator, Coolant Cooled.

11 - Ribbed Belt

• Checking ribbed belt, refer to => [ Ribbed Belt, Checking ] Testing and Inspection.

• Ribbed belt routing, refer to => [ Ribbed Belt Routing, Generator, Coolant Cooled ] Ribbed Belt Routing, Generator, Coolant Cooled.

12 - Collar Bolts

• 20 Nm

• M8 x 90 mm

13 - Idler Pulley

14 - Bolt

• 20 Nm

• M10 x 45 mm

15 - Cap

16 - Hex Socket Head Bolts

• 20 Nm

• M8 x 30 mm