Adjustable Tail Lamp Assembly Carrier in Side Panel

Adjustable Tail Lamp Assembly Carrier in Side Panel

• By, for example, damage to rear side panel or by replacing tail light assembly, it may be necessary to adapt tail light assembly by reason of unacceptable gap dimensions (body to tail light assembly). For this, an adjustable tail light assembly carrier must be installed.

• For technical reasons, it is not possible to offer a side panel with hole-punched holder for tail light assembly if repairs are required. In this case, a specially developed adjustable tail light assembly carrier is available, which must also be installed.

Adjustable lamp carrier consists of






• 1x - A - Clip mount 1.2 mm with plastic clip nut

• 2x - B - spacer pieces, 1 mm

• 2x - C - spacer pieces, 0.5 mm

• 1x - D - threaded plate

• 1x - E - mounting bolt

• 1x - F - mounting bolt