Cowl Moulding / Trim: Service and Repair

Windshield Wiper System

Plenum Chamber Cover, Removing

- Release the retainers - arrows - of the plenum chamber cover by turning them 90°.





- Carefully lift cover - 1 - slightly until harness connector for Sensor for air quality (G238) can be disconnected.

- Remove the cover.

• Plenum chamber cover is inserted below windshield in a guide rail.

• For reasons of clarity, illustration shows plenum chamber already removed.

- Loosen twist locks - 1 - of cover by a 90° turn.





- Carefully unclip plenum chamber cover upward - arrows -.






Windshield Wiper System

Plenum Chamber Cover, Installing

- Install plenum chamber cover in reverse sequence.