Front Bumper Attachments

Front Bumper Attachments

• Due to model variations, small deviations must be considered during removal and installation.





1 Cover

• Material - PP/EPDM

• Removing, refer to => [ Bumper Cover ] Bumper Cover

2 Right cover

• Clipped in cover.

• Only to be removed from removed bumper.

3 Center cover

• Clipped in cover.

• Only to be removed from removed bumper.

4 Left cover

• Clipped in cover.

• Only to be removed from removed bumper.

5 Decorative frame

• installed only on model variations without a center bar - 6 -.

• Only to be removed from removed bumper.

6 Center bar

• Depending on model variations, the center bar must be cut out using workshop tools.

7 Spoiler

• Clipped in cover.

• Material PC/ABS

• Only to be removed from removed bumper.

8 Left vent grille

• Clipped into spoiler.

9 Right vent grille

• Clipped into spoiler.

10 Spreader clip

• Quantity: 3

11 License plate holder

• Material PC/ABS

• Attaching:

- Hold license plate holder up to bumper and center.

- Mark the mounting points and drill 8 mm dia. holes. Do not drill deeper than 12 mm.

- The license plate holder is fastened with 3 spreader clips - 10 -.

12 License plate holder

• Material PC/ABS

• US vehicles only

• Attaching:

- Hold license plate holder up to bumper and center.

- Mark the mounting points and drill 8 mm dia. holes. Do not drill deeper than 12 mm.

- The license plate holder is fastened with 4 spreader clips - 13 -.

13 Spreader clip

• Quantity: 4

• Only for license plate holder for USA vehicles.

14 Left towing eye cover

15 Right towing eye cover

16 Left radiator grille cover

• Clipped into spoiler.

17 Right radiator grille cover

• Clipped into spoiler.

18 Reflector

• Only USA vehicles

• Left and right

• Clipped into spoiler.

• Can be carefully removed from exterior using a plastic wedge.