Right Flange Shaft Seal

Right Flange Shaft Seal

Special tools, testers and auxiliary items required

• Thrust Piece (T10105)

Removing

- Remove the noise insulation.

- Mark the location of the ball joint to lower control arm nuts - arrows -.






Use these locations for reassembly

- Remove the nuts - arrows - and separate the lower control arm from the ball joint.

- Place a drip tray below.

- Remove the right drive axle from the transmission.

- Secure the right drive axle up as high as possible to the strut.






- Pry out the seal being careful not to damage the shaft inside the transmission.

Installing

Install in reverse order of removal. Pay attention to the following:

- Lubricate the outer circumference and the sealing lip on the oil seal with transmission fluid.

- Install the seal all the way in using the thrust piece (T10105). Be careful not to tilt it.

- Install the right drive axle.

- Check the transmission fluid level and add if necessary. Refer to => [ Transmission Fluid Level, Checking and Filling ] Transmission Fluid Level, Checking and Filling.

- Install the noise insulation.