Steering Column Switch, Through 05.10, Airbag Spiral Spring/Return Spring With Slip Ring (F138)

Airbag Spiral Spring/Return Spring With Slip Ring (F138)


Follow the specified sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

Removing

• When removing, the spiral spring must not be twisted out of the center position and wheels must be in the straight ahead position.

- Lift straps - arrows - slightly at spiral spring - 1 - and remove spiral spring toward rear from steering column and steering column switches.






Installing

Install in reverse order of removal. Note the following:


The turn signal switch lever could break when installing the spiral spring.

The turn signal lever must be in the 0 position when installing the spiral spring so that it does not fall out.

• When installing spiral spring, spiral spring must be in center position and wheels must be in the straight ahead position.

The following shows the center position of the spiral spring, which depends on the manufacturer:

• The color marked (black square) band - arrow - must be located in viewing window - 1 -.






• The color marked (yellow) band - arrow - must be located in viewing window - 1 -.






• If a new Steering Angle Sensor (G85) is installed, then the work procedure => [ Steering Angle Sensor (G85) Basic Setting, Through 05.10 ] Testing and Inspection must be performed.