Glove Box Lamp: Service and Repair

Glove Compartment Lamp (W6)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned, using commercially available adhesive tape.

Removing

- Turn off the ignition and all electrical consumers.

- Carefully pry the lens - 1 - out with the (VAS 3409) or a screwdriver.






- Disconnect the harness connector - arrow - and remove the glove compartment lamp - 1 -.






Installing

Installation is performed in the reverse order of removal. Note the following:

- Check function of glove compartment switch. The glove compartment lamp must not light up when the cover is closed.