Rear Bass Speaker, 2-Door

Rear Bass Speaker, 2-Door

Removing

Before starting repair work, perform the following:

- Switch off ignition, switch off all electrical consumers and remove ignition key.

In order to replace speaker, side trim must first be removed.

• When removing side trim, treble speaker may break away from trim due to a short wire connector from wire mount to speaker connector - arrows -. Therefore, carefully remove side trim.





- Disconnect connector at treble speaker and then remove side trim.

- Release locking mechanism of harness connector - arrows - and disconnect it.





- Using a suitable drill, drill out rivets - arrows - and remove loudspeaker.





• To prevent corrosion, ensure that all metal particles from drilling are removed from inside the side panel.

• If paint on door frame is damaged during drilling, touch-up immediately.

Installing

- When installing, secure new speaker with special pop rivets (note replacement part number!).

Further installation is in the reverse sequence to removal.