Noise Insulation, Short Version, Assembly Overview

Noise Insulation, Short Version, Assembly Overview

• Slight changes may have to be made to removal and installation procedures, depending upon engine installed in vehicle.





1 Noise Insulation

• - arrow a - points in the direction of travel

• Removing:

- Remove screws - 2 and 3 -.

- Pull the noise insulation toward the rear out of the lock carrier mounts.

• Installing:

- Push the noise insulation in the - direction of arrow b - into the lock carrier mounts.

- Tighten screws - 2 and 3 -.

2 Bolt

• Quantity: 1

• Tightening specification: 2 Nm

3 Bolt

• Quantity: 6

• Tightening specification: 2 Nm