Noise Insulation, Long Version, Assembly Overview

Noise Insulation, Long Version, Assembly Overview

• Slight changes may have to be made to removal and installation procedures, depending upon engine installed in vehicle.

• The screws - 3 - are microencapsulated and therefore must be replaced after loosening.





1 Noise Insulation

• - arrow a - points in the direction of travel

• Removing:

- Remove the bolts - 2, 3 and 4 -

- Pull the noise insulation toward the rear out of the lock carrier mounts.

• Installing:

- Push the noise insulation in the - direction of arrow b - into the lock carrier mounts.

- Tighten the bolts - 2, 3 and 4 -.

2 Bolt

• Quantity: 1

• Tightening specification: 2 Nm

3 Bolt

• Quantity: 6

• Tightening specification: 2 Nm

4 Bolt

• The screws are microencapsulated.

• Always replace the bolts after loosening.

• Quantity: 2

• Tightening specification: 6 Nm