Transmission Output Speed Sensor

Transmission Output Speed Sensor

Removing

- Remove the valve body. Refer to => [ Valve Body ] Valve Body.

- Remove the bolt - 2 - for the transmission output speed (RPM) sensor (G195).





- Remove the sensor from the transmission.

Installing

Installation is performed in the reverse order of removal. Pay attention to the following:

- Press the sensor into the transmission until seated.

- Tighten bolt - 2 - for the transmission output speed (RPM) sensor, tightening specification, refer to => [ Fastener Tightening Specifications ] Fastener Tightening Specifications.

- Install the valve body. Refer to => [ Valve Body ] Valve Body.