Rear Suspension

Front Wheel Drive

Vehicle Level Sensor

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1410)

Removing

- Disconnect the connector - 1 -.





- Remove the bolts - 2 - from the lower transverse link.

- Remove bolts - arrows - from the subframe.

- Remove left rear level control system sensor ( G76).

Installing

Installation is in reverse order of removal. Observe the following when doing so:

The left rear level control system sensor lever must point toward the outside of the vehicle.

- After replacing, perform a headlamp basic setting => Vehicle Diagnosis, Testing, and Information System VAS 5051 in "Guided Fault Finding" function

Tightening Specifications





Vehicle Level Sensor with Automatic Headlamp Range Control

• Vehicle level sensor is available as replacement part only complete with coupling rod and upper and lower retaining plates.

• Replacing with subframe installed.

• Headlamp Range Control Module (J431)





1 Subframe

2 Lower transverse link

3 Bolt

• 5 Nm

4 Left Rear Level Control System Sensor (G76)

• Complete with components

• Lever - arrow - must point toward vehicle exterior

• Replace in vehicle

• After replacing, perform basic setting of the headlights

Perform basic setting on headlamps with.